After a User Credential has been assigned to a Pivot Pro+ lock, the Programming Card can quickly program multiple locks to operate with the same Management Cards and User Credentials. Make sure that the lock is set for Assigned Use functionality (a green LED will flash when a hand is presented to a Pivot Pro+ lock).
Go to a lock already programmed to operate with the Management Cards and User Credentials. Present hand to lock and hold for 15 seconds. The LED will flash green, then turn red and beep once after 5 seconds. It will continue to flash green, then turn red and beep twice after 10 seconds. Lastly, it will flash green, then turn red and beep three times after 15 seconds.
Remove hand. While the LED is flashing green, present the Programming Card. The LED will stop flashing, beep, then turn red.
Present the Programming Card to program each lock to operate with the same Management Cards and User Credentials. The LED will turn green and beep to indicate successful programming.
End Express Registration mode.* Go to any programmed lock. Present hand to lock and hold for 5 seconds. The LED will flash green, then turn red and beep after 5 seconds.
Remove hand. While the LED is flashing green, present the Programming Card. The LED will turn red and beep, followed by flashing green again. Once the flashing stops, the Express Registration mode is complete.
After completing these steps, the Assigned Use RFID locks are ready for use. For operating instructions, go to How to operate a Pivot Pro+ lock in Assigned Use.
