The Programming Card can quickly program multiple Pivot Pro+ locks to operate with the same Management Cards.
Go to a lock already programmed to operate with the Management Cards. Present hand to lock and hold for 10 seconds. The LED will flash red, then turn green and beep after 5 seconds. It will continue to flash red, then turn green and beep again after 10 seconds.
Remove hand. The LED will turn green and beep, then start flashing red. While the LED is flashing red, present the Programming Card. The LED will turn green and beep.
Present the Programming Card to program each lock to operate with the same Management Cards. The LED will turn green and beep to indicate successful programming.
End Express Registration mode.* Go to any programmed lock. Present hand to lock and hold for 5 seconds. The LED will flash red, then turn green and beep after 5 seconds.
Remove hand. While the LED is flashing red, present the Programming Card. The LED will turn green and beep, followed by flashing red again. Once the flashing stops, the Express Registration mode is complete.
If you're setting up a new site installation, then after completing these steps, Shared Use Pivot Pro+ locks are ready for use. For operating instructions, go to How to operate a Pivot Pro+ lock in Shared Use.
*The Programming Card will continue to function in Express Registration mode until it is manually ended.
