After a User Credential has been assigned to a keypad lock, the Programming Key can quickly program multiple locks to operate with the same User and Manager Credentials. Make sure that the lock is set for Assigned Use functionality (a green LED will flash when "C Button" is pressed on a keypad lock).
The images shown are for illustration purposes only and may not be an exact representation of your product.
Go to a lock already programmed to operate with the User and Manager Credentials.
"Press C Button+Key Button+6+6+Key Button". The LED will turn on.
Insert the Programming Key. Two sets of two-tone confirmation beeps will be heard and the LED will turn off.
Insert the Programming Key to program each lock to operate with the same User and Manager Credentials. Two sets of two-tone beeps will be heard and the LED will flash to indicate successful programming.
End Express Registration mode.* Go to any programmed lock and override it with the Programming Key.
Deadbolt: "Press C Button+Key Button" then insert the Programming Key. The lock will engage. "Press C Button+Key Button" again, then insert the Programming Key to return the bolt to the original position.
Deadlatch and Cam: "Press C Button+Key Button" then insert the Programming Key to operate the lock.
After completing these steps, the Assigned Use keypad locks are ready for use. For operating instructions, go to How to operate a keypad lock in Assigned Use.
*The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.
