The Programming Card can quickly program multiple Assigned Use Pivot Pro+ locks to operate with the same Management Cards.
Go to a lock already programmed to operate with the Management Cards. Present hand to lock and hold for 10 seconds. The LED will flash green, then turn red and beep after 5 seconds. It will continue to flash green, then turn red and beep twice after 10 seconds.
Remove hand. While the LED is flashing green, present the Programming Card. The LED will stop flashing, beep, then turn red.
Present the Programming Card to program each lock to operate with the same Management Cards. The LED will turn green, beep, then turn red to indicate successful programming.
End Express Registration mode.* Go to any programmed lock. Present hand to lock and hold for 5 seconds. The LED will flash green, then turn red and beep after 5 seconds.
Remove hand. While the LED is flashing green, present the Programming Card. The LED will turn red and beep, followed by flashing green again. Once the flashing stops, the Express Registration mode is complete.
If you're setting up a new site installation, go to How to assign User Credentials to an Assigned Use Pivot Pro+ lock.
*The Programming Card will continue to function in Express Registration mode until it is manually ended.
