The Pivot Pro+ locks must be reprogrammed to prevent lost/stolen cards from operating the lock.
How to replace the Programming Card
Contact Digilock Support to purchase a Replacement Programming Card.
How to replace Management Cards on an Assigned Use Pivot Pro+ lock
Go to any lock operated by the lost/stolen Management Cards. Present hand to lock and hold for 5 seconds. The LED will flash green, then turn red and beep after 5 seconds.
Remove hand. While the LED is flashing green, present the Programming Card. The LED will turn red and beep, followed by flashing green again.
While the LED is flashing green, present the Programming Card again. The LED will stop flashing, beep twice, then turn red. All previously programmed Management Cards will be erased.
Collect any remaining or replacement Management Cards and follow the How to add Management Cards to an Assigned Use Pivot Pro+ lock instructions to program them to the Assigned Use Pivot Pro+ locks.
