All Pivot Pro+ locks are shipped with factory default settings. To program the Assigned Use Pivot Pro+ locks and prepare them for use, they must be set up to operate with a Programming Card and Management Card(s). A Programming Card and at least one Management Card will be needed to complete this process.
With the door open, present the Programming Card to the RFID reader. The lock will initialize, the LED will turn red and beep, then flash green.
While the LED is flashing green, present each Management Card one at a time. The LED will turn red and beep for each Management Card programmed.
NOTE: If the LED stops flashing green and there are still more Management Cards to add, follow the How to Add Management Cards to an Assigned Use Pivot Pro+ lock instructions.
Present the Programming Card. The LED will stop flashing, beep twice, then turn red. Close the door. The LED will flash green, then turn red.
Repeat previous steps for each lock or follow the How to Express Register Management Cards to multiple Assigned Use Pivot Pro+ locks instructions to set up all locks.
After completing these steps, go to How to assign User Credentials to an Assigned Use Pivot Pro+ lock to complete the setup.
